DCA Vane Angle Tool (VAT) target X-Small - 600 & 700

X-Small - 600 & 700 spine - 9

The Beiter Klicker has been used and appreciated since its introduction

can be assembled on front or back of the riser

All New PSE E2 & S2 Cams- Specifically designed for maximum energy transfer from limbs to arrow

All metal drop away with bearings this is the same as the PSE drop away rest

DCA Vane Angle Tool (VAT) target X-Small - 600 & 700Use this patented tool to precisely set up your Bitzenburger fletching jig to the desired helical (or offset) angle. The wrap shows angles from 0 6 degrees left or right and is attached to a 7 section of 0. 204 ID arrow and includes a nock. Just place an arrow in the clamp, turn the nock so that the bottom corner of the vane is in the crosshair as shown and adjust the dials on the jig. This works with the straight and helical clamp. The helical clamp